Pole machine is mainly used in the transformation of rural power electricity, stand 8-15 m tower power pole with cement. Pole machine is roughly divided into three aluminum tripod pole machine Derrick lattice aluminum Derrick. Lifting is the largest amount of aluminum tripod pole machine and easy to use, easy to operate, three people stand work can be completed cement rod. Tripod pole machine consists of three aluminum tube and a two-speed gearbox constitute hand, construction safety, high efficiency, one hour can stand three cement pole, to solve the local mountain hills crane alley bad job, easy to transport . Aluminum tubes used in all standard GB Tianjin aluminum production of 100mm * 4mm 100mm * 5mm 120mm * 4mm 120mm * 5mm aluminum pole machine 8-10 meters into the cement pole dedicated, main stem length 7.m pay rod 6.3 m long general diameter 100mm * 10-12 meters using cement pole dedicated master rod length 7.4 m, 6.7 m long sub-rod, the general diameter using 100mm * 4mm, can bear 3 tons weight, equipped with 5 tons of hand gearbox. 12 m -15 m cement pole dedicated main lever 8 meters long, 7.5 m diameter sub-rod commonly used 100mm * 5mm or 120mm * 4mm, can take three tons weight. Product Name: Aluminum tripod pole machine use: aluminum pole machine is suitable for pole, lifting the lower shaft cable, strand and other goods. Feature: Main material with the highest strength aluminum alloy, reliable and secure. The pole machine do not play the anchor lifting gear, high safety factor, the three men to complete the set of frame and pole tools, with two-speed hand winch, lifting tasks can be easily completed. The product is small, light weight, flexible and convenient insurance, factor, solve the crane can not carry out site and artificial pole problem risk of large, urban alleys or construction Mid-hilly areas to better reflect its characteristics, the entire pole complete process takes only a few people in just ten minutes. Winch Features: The new fast and slow two-speed hand cutter grinding, easy operation, long life cutter grinding. The maximum output power of 20KN, combined with double pulley blocks, single pole shaking cutter grinding to complete the work. Derrick Aluminum is the most commonly used by two aluminum tubes, equipped with a separate hand cutter mill, 100 m oil wire rope, use the method, the two pipes directly into the ground, the base dioica There are sharp points, to stabilize the hand cutter mill, Steel Wire Rope good, the mating pulley installation, 15 m aluminum pole machine specification aluminum pole machine aluminum production plant in Tianjin High raw materials, factory technical staff through the years development, development, is to officially put on the market, aluminum pole machine is small, light weight, flexible, convenient insurance, factor, solve the space and artificial pole problem risk crane can not be (Mid Hills Strip construction) to better reflect its characteristics, the entire process takes only a few people Pole completed in a short period of ten minutes. 15 m pole machine operating procedures: 1, support from two aluminum pole (angle according to the construction site may be), 2, confidential on hand a large stable of more than 15 meters distance from the pit (Note: a large stable ! machine, poles, pit must be in a horizontal line, is the best pole angle) 3, the land of the large stable machine firmly anchored well in all parts of a good check before pole 4, the discharge poles Note: Line butt rod immediately facing the pit, pole-tip lower rope to be equipped with rod pocket, 5, oil wire trap poles, 3.5 m at set online lever fine head, both sides use the help of rope tied Okay! 6. Check all parts well then you can shake a large stable machine slowly erected the poles.

keywords: Pole machine,